Avocent MERGEPOINT 53XX SP MANAGER User's Guide download pdf (Page 45)

3. For dynamic DHCP, specify the Start and End IP range of addresses in the dynamic DHCP

area.

-or-

For static DHCP, click Add in the Static IP area and specify the requested parameters.

4. Click Apply.

NOTE: To modify a static IP address, click on the name of the IP address and follow the on-screen instructions. To

delete a static IP address, select the check box next to the name and click Delete.

To stop or start the DHCP service:

1. Click SP - DHCP.

2. Click Stop or Start as appropriate.

To configure the DHCP relay server:

1. Click SP - DHCP.

2. In the Status area, select Enable to activate DHCP relay.

3. In the Server field, enter the IP address or the name of the DHCP relay server.

4. Click Apply.

NOTE: DHCP settings may also be changed using the CLI utility. See the related CLI commands in Summary of

How to Configure the Top Level Parameters on page 136.

Service Processor Licenses

A license is required for each SP managed by the MergePoint SP manager. Blade chassis require

a license for the chassis itself and for each blade housed in the chassis.

The MergePoint SP5x24/SP5x40 manager includes 64 SP licenses and additional licenses

cannot be purchased. The MergePoint SP5x00 manager includes 64 SP licenses and additional

license keys (slave keys) can be purchased in increments of 64 or 128, with a maximum of 256

SP licenses per appliance.

To add service processor license keys (slave keys) to the MergePoint SP5x00

manager:

1. Click the System tab.

2. In the top navigation bar, click Licenses. The License window appears.

3. Click Add Slave Key and enter the key.

4. Click Apply.

Chapter 2: Installation and Setup 33

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 235 236

No comments

Avocent MERGEPOINT 53XX SP MANAGER User's Guide Page 45