Avocent MERGEPOINT 53XX SP MANAGER User's Guide download pdf (Page 117)

User shell

After logging in the MergePoint SP manager console via SSH command or SSH applications

(such as PuTTY or Telnet) non-admin users see a menu like the one shown in the following

example.

Access Devices

Change Password

Logout

Admin users can get to the same menu either by entering the rmenush command on the SSH

command line or by entering /usr/bin/rmenush on the command line after login. You can move

from one item to another on the menu and submenus by using the keyboard arrow keys. A line

(-) appears next to the selected item.

When Access Devices is selected, a menu appears with a list of devices that the user is

authorized to access. After a device is selected, pressing the Enter or Return key brings up the

list of actions the user is authorized to perform on the device.

Not all listed actions are supported for all service processors. The following example shows the

service processor action menu for an HP iLO/iLO2 service processor.

HP iLO/iLO2

Access the service processor's console

Access the device's console via SoL

Manage power

Reset SP

Manage the event log

View sensor output

Start Telnet session

Start SSH session

Enable native IP

Disable native IP

Exit

Back

NOTE: If you select Start Telnet session or Start SSH session, you are prompted for the corresponding port, and

then required to enter the username and password.

NOTE: The Enable native IP and Disable native IP commands are only supported on the MergePoint

SP5x24/SP5x40 manager.

Chapter 6: Administration Tasks Not Performed in the Web Interface 105

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 235 236

No comments

Avocent MERGEPOINT 53XX SP MANAGER User's Guide Page 117