Avocent MERGEPOINT 53XX SP MANAGER User's Guide download pdf (Page 138)

bootconf iptables pxe sshd tcpdump

Pressing Tab once after partially typing a parameter name automatically completes the

parameter name, unless there is more than one parameter name beginning with the typed

characters. If more than one parameter name begins with the typed characters, then Tab Tab

displays them all.

NOTE: The bootconf and cards commands are only for MergePoint SP5x24/SP5x40 manager.

Examples

cli> s<Tab><Tab>

set shell show

cli> se<Tab>

cli> set

cli> set n<Tab><Tab>

network ntp

cli> set ne<Tab>

cli> set network

cli> set network <Tab><Tab>

hostname hosts interface resolv st_routes

cli> set network i<Tab>

cli> set network interface

cli> set network interface eth0 <Tab>

address alias gateway method mtu netmask

address6 broadcast gateway6 method6 mtu6 netmask6

CLI Commands

The CLI utility supports the commands that are described in the following sections with

examples.

cli> <Tab><Tab>

add commit exit list rename set show

cd delete get quit revert shell version

add

The add command adds the last parameter and sets it to the default value (if any). Any

nondefault values must be set using the set command.

The add command is used instead of set when multiple parameters of the same type can exist.

For example, add network hosts <IP address> makes an entry for a host with the specified IP

address in the hosts list. In that case, add is used because multiple hosts can exist.

126 MergePoint® SP Manager Installer/User Guide

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 235 236

No comments

Avocent MERGEPOINT 53XX SP MANAGER User's Guide Page 138