Avocent PM3000 User's Guide download pdf (Page 72)

IPv4 and IPv6 Static Routes Navigation Tree

gateway=

interface=

metric=

ipv6_static_routes

Network/Devices

The procedure to configure a static IP address for the primary Ethernet interface is usually

performed during installation so that administrators have a fixed IP address for access to the

web manager and can finish configuration.

To configure a IPv4 or IPv6 static IP address:

NOTE: This procedure configures either an IPv4 or IPv6 static IP address for the ETH0 (eth0) port. You can

configure an IPv6 static IP address only if IPv6 is enabled.

1. Type cd network/devices/<eth0>/settings to navigate to the Settings level for the desired

interface.

--:- / cli-> cd network/devices/eth0/

2. Type set ipv<4|6>_method=static to set the method to static for IPv4 or IPv6.

**:- eth0 cli-> set ipv4_method=static

3. Type set ipv<4|6>_method/static/ address=<IP_Address> mask=<netmask> to set the IP

address and subnet mask then enter commit to save the change.

--:- eth0 cli-> set ipv4_method/static/ ipv4_address=172.26.31.10 ipv4_

mask=255.255.255.0

**:- eth0 cli-> commit

4. Type show to view the changes.

--:- eth0 cli-> show

Devices Navigation Tree

devices

eth0

Table 4.8: Network/Devices Options

64 Avocent PMPDU Installer/User Guide

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 116 117

No comments

Avocent PM3000 User's Guide Page 72