Avocent PM3000 User's Guide download pdf (Page 39)

NOTE: The MAC Address for the device will be displayed after this option.

IPv4 and IPv6 static routes

An administrator can select Network - IPv4 Static Routes or IPv6 Static Routes to configure

static routes.

To add static routes:

1. Select Network - IPv4 Static Routes or IPv6 Static Routes. Any existing static routes are

listed with their Destination IP/Mask, Gateway, Interface and Metric values shown.

2. Click Add.

3. Select Default to configure the default route.

-or-

Select Host IP Or Network to enter custom settings for Destination IP/Mask.

Enter the required Destination IP/Mask Bits with the syntax <destination IP>/<CIDR>

in the Destination IP/Mask Bits field.

4. Enter the IP address of the gateway in the Gateway field.

5. Enter the number of hops to the destination in the Metric field, then click Save

Hosts

An administrator can configure a table of host names, IP addresses and host aliases for the local

network.

To add a host:

1. Select Network - Hosts.

2. Click Add to add a new host.

3. Enter the IP address, hostname and alias of the host you want to add, then click Save.

To edit a host:

1. Select Network - Hosts.

2. Click on the IP address of the hostname you want to edit.

3. Enter a new hostname and alias, as applicable, then click Save.

Firewall

Administrators can configure the PM PDU to act as a firewall. By default, three built-in chains

accept all INPUT, FORWARD and OUTPUT packets. Select the Add, Delete or Change Policy

Chapter 3: Accessing a PM PDU via the Web Manager 31

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 116 117

No comments

Avocent PM3000 User's Guide Page 39