Avocent PM3000 User's Guide download pdf (Page 38)

Information

Click System-Information to view the PM PDU’s identity, versions and CPU information.

Usage

Click System-Usage to view memory and Flash usage.

Network

Click Network to view and configure the network options for Hostname, DNS, IPv6, IPv4 and

IPv6 static routes, Hosts, Firewall and SNMP.

Settings

Click Network - Settings to make changes to the configured network settings.

Devices

An administrator can select, enable and configure the IP addresses assigned to the network

interface and view the MAC address. A PM PDU has a single eth port and cannot have any

plugged in eth port.

To configure a network device:

1. Select Network - Devices. The Devices screen appears with a list of network interfaces and

their status (enabled or disabled).

2. Click the name of the network device to configure.

3. Select the status (either Enabled or Disabled) from the drop-down menu.

4. Select one of the following IPv4 method options:

• Select DHCP to have the IPv4 IP address set by the DHCP server.

• Select Static to enter the IPv4 IP address and subnet mask manually.

• Select IPv4 address unconfigured to disable IPv4.

5. Select one of the following IPv6 method options:

• Select Stateless if the link is restricted to the local IP address.

• Select DHCPv6 to have the IPv6 IP address set by the DHCP server.

• Select Static to enter the IPv6 IP address and prefix length manually.

• Select IPv6 address unconfigured to disable IPv6.

6. Select the Ethernet Mode for the built-in interface (ETH0).

30 Avocent PMPDU Installer/User Guide

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 116 117

No comments

Avocent PM3000 User's Guide Page 38