Avocent AMWorks User's Guide download pdf (Page 51)

CHAPTER

Managing Servers and

Server

Groups

The AMWorks software enables you to manage servers and server groups as listed below. For an

introduction to user and server groups, see

User groups and server groups on page 93.

By using AMWorks software to manage servers and server groups, you can:

• Display information about servers (see Editing and Viewing Servers on page 46)

• Display and change a server’s configuration information (see Editing and Viewing Servers on

page 46)

• Display and change configuration information for an MDM-capable device (see Editing and

Viewing MDM-Capable Devices on page 53)

• Set audio and serial for servers (see Setting Audio and Serial for Servers on page 28)

• Set global audio and serial for users and servers (see Setting Global Audio and Serial for Users

and Servers on page 28)

• Add and remove server groups (see Adding and Removing Server Groups on page 43)

• Display and change server group configuration information (see Editing and Viewing Server

Groups on page 47)

• Display server memberships in server groups (see Editing and Viewing Server Groups on

page 47)

• Remove server groups (see Adding and Removing Server Groups on page 43)

Adding and Removing Server Groups

Follow the instructions below to add or remove server groups in the AMX switching system. For

more information, see

User groups and server groups on page 93 for more information.

NOTE: If you create server groups in your system, you must use the AMWorks software for all subsequent user

access rights changes on the system. If you make any subsequent changes from an AMX user station OSCAR

interface, the system will go out of sync. See

Synchronization status indicator turns red on page 98 for

more information.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 112 113

No comments

Avocent AMWorks User's Guide Page 51