Avocent CCM4850 User Manual download pdf (Page 63)

Chapter 5: CCM Appliance Commands 51

Syntax

SERVER FLASH BOOT|APP HOSTIP=<tftp_add> IMAGE=<host_file>

Example

The following command updates the boot image program using the image file name

c:\winnt\system32\drivers\ccm50bt.img, which is located on the TFTP server host located at

192.168.1.16.

> ser fla app hostip=192.168.1.16

c:\winnt\system32\drivers\ima=ccm50bt.img

Server PPP command

The Server PPP command enables or disables the PPP server on the console port. For more

information and requirements, see Connecting to devices using PPP on page 15 and Configuring

and using dial-in connections on page 14.

Once the PPP server has been configured with this command by specifying the required addresses

and masks, those values remain in the database. Later, if you disable the PPP server and wish to

reenable it with the same addresses, you don’t need to specify the address values again.

When you enter this command, you are prompted to confirm or cancel the specified changes.

Access right: SCON

Access level: APPLIANCEADMIN

Syntax

SERVER PPP DISABLE|ENABLE

[LOCALIP=<local_ip>] [REMOTEIP=<rem_ip>] [MASK=<subnet>]

Table 5.11: Server FLASH Command Parameters

Parameter Description

BOOT|APP

Indicates either the boot image should be updated or the application image should

be updated.

HOSTIP=<tftp_add> IP address of TFTP server host.

IMAGE=<host_file> Name of file on TFTP server host containing the image file.

Table 5.12: Server PPP Command Parameters

Parameter Description

DISABLE|ENABLE Disables or enables the PPP server.

LOCALIP=<local_ip>

IP address to be used to connect the CCM appliance over the PPP connection. Must

be on same subnet as REMOTEIP address.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 99 100

No comments

Avocent CCM4850 User Manual Page 63