Avocent CCM4850 User Manual download pdf (Page 18)

6 CCM4850 Installer/User Guide

Figure 2.2 shows the back panel of a CCM4850 appliance.

Figure 2.2: CCM4850 Appliance Back Panel

The back panel contains:

• The AC line cord connector.

• On/off switch (

O = off, | = on).

• Outflow openings for the two internal fans.

• A DB-9 DEBUG PORT connector. This port should be used only on the advice and with the

guidance of Equinox Technical Support.

Installing the CCM Appliance

WARNING: This unit is not user serviceable. To avoid electrical shock, do not attempt to open the unit or operate

with the cover off. Do not attempt to make any repairs. See Appendix E on page 81 for information.

WARNING: The power outlet should be near the equipment and easily accessible.

To install the CCM appliance hardware:

1. Place the unit where you can connect cables between the serial devices and the CCM serial

ports, and where you can connect a LAN interface cable between the Ethernet hub or switch

and the CCM LAN PORT connector.

2. Connect serial devices to the CCM serial ports; see Device Cabling on page 73 for cable infor-

mation. Connect each serial device to its appropriate power source, following the

device’s documentation.

Green On Link at 100 Mbps

Orange On Link at 1000 Mbps

Off Flashing Traffic at 10 Mbps

Green Flashing Traffic at 100 Mbps

Orange Flashing Traffic at 1000 Mbps

Table 2.1: LAN LED Values (Continued)

SPEED LED LINK/TRAFFIC LED Description

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 99 100

No comments

Avocent CCM4850 User Manual Page 18