Avocent Cyclades ACS Service Manual download pdf (Page 19)

Chapter 2: Network Configuration 11

NOTE: If services not supporting IPv6 are needed, select Dual Stack (IPv4 and IPv6) and those services will be

available for IPv4.

IPv4 Addressing

To enable IPv4 network addressing:

1. From the shell prompt on your terminal, enter the following command.

# CLI

2. From the cli prompt, enter the following:

cli> config network hostsettings ipmode dualstack

This will enable both IPv4 and IPv6 network addressing.

-or-

cli> config network hostsettings ipmode ipv4

This will enable IPv4 network addressing only.

To set IPv4 specific configurations:

From the cli prompt, enter the following.

cli> config network hostsettings

Follow the parameters in Table 2.1 for the rest of the configuration.

IPv6 addressing

Services not supported in IPv6

IPv6 does not support the following services:

• NIS authentication

• NFS data logging

Table 2.1: IPv4 Specific Configurations

IPv4 Specific Level 1 IPv4 Specific Level 2 Description

primipaddress <nnn.nnn.nnn.nnn> The primary IP address of the console server -

automatically obtained if DHCP is enabled

secipaddress <nnn.nnn.nnn.nnn> The secondary IP address of the console server

primsubnetmask <nnn.nnn.nnn.nnn> Subnet mask for the primary IP address

secsubnetmask <nnn.nnn.nnn.nnn> Subnet mask for the secondary IP address

dhcp <nnn.nnn.nnn.nnn> An IPv4 address will be dynamically obtained from a

DHCPv4 server

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 151 152

No comments

Avocent Cyclades ACS Service Manual Page 19