Avocent Cyclades ACS Service Manual download pdf (Page 143)

Appendices 135

Boot configuration

To configure boot parameters:

1. Use the following command to configure the boot parameters of the console server. Refer to

Table B.2 for the description of parameters.

cli> config administration bootconfig [parameter] <value>

2. Activate and save your configuration.

CLI administration parameters

The administration section of the CLI interface is divided into three parts.

• Session management

• Backup configuration

• Firmware upgrade

Table B.2: CLI Boot Configuration Parameters

Parameter Value Description

boottype bootp | both | tftp To set the network boot type.

bootunit network To set from where the unit boots.

consolespeed 115200 | 19200 | 38400 | 4800 | 57600 | 9600 To configure the console speed.

ethernetip ethernetip | ethernetmode Assign a temporary IP address to the

Ethernet interface.

ethernetmode 100F | 100H | 10F | 10H | auto To set an Ethernet mode.

filename <filename> Add a filename of the image on the tftp server.

flashtest full | skip Enable or disable the Flash test.

maxevents <number> Set maximum number of Ethernet events

handled at once.

ramtest full | quick | skip Select a type of ram test.

tftpserver <n.n.n.n> Set the IP address of the tftpserver.

wdt off | on Enable or disable watch dog timer.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 151 152

No comments

Avocent Cyclades ACS Service Manual Page 143