Avocent DSView 3 User's Guide download pdf (Page 28)

22 DSView Installer/User Guide

5. You will see a list of ports and a corresponding drop-down menu beside it.

Using the drop-down menu, select the number of channels supported by

the KVM switch you are conﬁ guring.

Repeat this procedure for every KVM switch you plan to configure. Click OK

when complete.

After all DS/DSR appliances are configured, you may add CPS appliances and

SPC devices to the system.

To add a new CPS appliance to the system:

1. Load the DSAdmin software.

2. Double-click on the icons labeled Topology and then Your Network. A listing of

all DS appliances accessible by the system will be displayed.

3. First, you must configure the CPS appliance for use with a DS/DSR appli-

ance. Begin by establishing a Telnet session to your CPS appliance. From

the CPS command line, enter the following command:

SERVER SECURITY MODE=DSSSL DSAUTH=[Authentication Address]

In place of [Authentication Address], enter the proper information for

your DS/DSR appliance.

In configurations where security is enabled, enter the primary DSAuth

Server’s IP address followed by the secondary server.

For example:

SERVER SECURITY MODE=DSSSL DSAUTH=111.11.11.1, 222.22.22.2

In configurations where security is not enabled, enter the word any.

For example:

SERVER SECURITY MODE=DSSSL DSAUTH=any

Press Return to accept the configuration.

4. From DSAdmin, select File - New - CPS. The Properties dialog box

will appear.

5. In the Device Identification tab, enter the IP address for the CPS appliance

that you are adding. This is the IP address that you assigned in the Terminal

Applications menu. See the CPS Installer/User Guide for more information.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 107 108

No comments

Avocent DSView 3 User's Guide Page 28