Avocent 1000R User Manual download pdf (Page 16)

10 AutoView 1000R/ AutoView 2000R Installer/User Guide

Setting up your network

The AutoView 1000R/2000R appliance uses IP addresses to uniquely identify

the appliances and the computers running AVWorks software. The AutoView

appliance supports both BootP (a subset of DHCP) and static IP addressing.

Avocent recommends that IP addresses be reserved for each appliance and

that they remain static while the appliances are connected to the network.

Rack Mounting Your AutoView 1000R/2000R

Your AutoView 1000R/2000R appliance ships with rack mounting brackets for

easy integration into your rack. Before installing the appliance and other

components in the rack cabinet (if not already installed), stabilize the rack in a

permanent location. Install your equipment starting at the bottom of the rack

cabinet, then work to the top. Avoid uneven loading or overloading of

rack cabinets.

To install the 1U switch mounting bracket:

1. Line up the holes in the “long side” of the kit’s side brackets with the

screw holes in the switch.

2. With a Phillips screwdriver, fasten the mounting brackets to the switch

using two 8/32 ” x 1//2 ” pan head screws on each side.

3. Attach the four cage nuts or clip nuts to the rack mounting ﬂ ange of the

rack cabinet so that the nuts are positioned on the inside of the rack.

4. Mount the switch assembly to the rack cabinet by matching the holes in

the “short side” of each bracket to an appropriate set of matching holes on

your rack cabinet. Next, insert the combination hex head screws through

the slots in the bracket and the holes in the mounting rail, then into the

cage nuts or clip nuts.

Figure 2.1: AutoView 1000R/2000R Horizontal Installation

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

No comments

Avocent 1000R User Manual Page 16